|
|
| Broad, flat rim, sloping to center.
Horizontal, broad handle broken. Long, deep nozzle, with small wick hole.
Fairly high base; unglazed.
Hard black glaze.
Pale red Attic clay.
Type VI (late 5th. century ... 16 June 1931 |
Fragment of bottom.
On bottom, single circular groove, with signature.
Traces of brown glaze on the side wall.
Buff clay.
Type XVIII (post Sullan) of Corinth collection, Signed Bases type of Agora collection ... 16 June 1931 |
| On rim, raised ovules around small flat top.
Double convex body; vertical handle; end of nozzle broken.
Fairly high base, inscribed: "IAΦH".
Glaze black metallic, with silvery sheen.
Pale red clay.
Type ... 3 July 1931 |
| Lamp is attached to a high standard of which the front is in the form of a column.
From the ridged necking spring two volutes; between them are raised loops, and below, above the necking, a band of raised ... 25 July 1931 |
Fragment of base pierced for standard.
Above a small high well finished base a bit of the body of the lamp, curving upwrad, is preserved; the center of the interior rises in a sharp cone, point broken, ... 15 July 1931 |
| Fragment of nozzle and rim. Lower half and tip of nozzle missing.
Rather narrow rim, sloping towards the central opening; set off from the side by an unglazed groove. Fairly broad nozzle, flat on top; ... 21 July 1931 |
Miniature lamp.
Rim merges with the body; at the inner edge, a groove, and a small ridge round the central opening.
Sides curving outwrad toward junction with rim. Irregular nozzle, spoon-shaped; rather ... 22 July 1931 |
Front part of lamp.
Rim merging with sides; broken along inner edge; close to the break, traces of a reserved band.
Short nozzle, shallow, rounded, encroaching on rim. No base; under surface slightly concave ... 10 August 1931 |
Nozzle and fragment of rim preserved.
On rim, single rill, its bottom reserved.
Nozzle long and deep, scratched in dry clay of its top.
Thin, somewhat metallic black glaze inside and outside.
Fine red ... 17 July 1931 |
Nozzle and front half of infundibulum preserved.
On rim, single groove around filling hole. Mold made.
Traces of knob of left side of body.
Nozzle long, rounded at tip, line of attachment to body on either ... 1931 |
| Nozzle and fragment of rim preserved.
Rim, carried up as a high ridge surrounding the filling hole, around this ridge is a double row of triangles in low moulded relief.
Long, pointed nozzle, flat on top ... 6 July 1931 |
| Rear part of rim and infudibulum preserved. Vertical, strap handle missing.
The top is depressed surrounded by a high lange, the part of rim preserved shows two small holes. Sharply angular. On shoulder, ... 29 August 1931 |
| Double convex body, with triangular nozzle and low, concave base.
On rim, imbricated leaf pattern.
On top, moulded rim around central filling hole. Remains of vertical band handle.
Traces of black glaze ... 29 January 1932 |
Tip of nozzle missing.
Double convex body, with concave top. Wheel made.
Rising vertical band handle, broken at back; long nozzle.
Slightly rising bottom, with central raised disc; base indicated by groove ... 6 February 1932 |
Double convex body, upper part deeper than lower. Traces of pierced knob on left side. On top, two shallow, concentric grooves; edges of filling hole, broken away, probably rose a little.
Nozzle, pointed, ... 12 February 1932 |
| No handle or knob.
Squat body, rounding, merging with rim from which it is set off only by a very shallow groove.
Nozzle, fairly flat on top, but rounding toward wick hole. Nozzle is long and pointed; ... 16 February 1932 |
| End of nozzle broken away.
Double convex, shallow body, the lower part rather deeper than the upper; join between lower part and moulded upper part clearly seen.
On rim, plain round filling hole; set off ... 19 February 1932 |
Fragment of nozzle and top.
Long nozzle, fairly deep, with rather small wick hole. Top flat with incurving sides. Not quite full depth of nozzle preserved.
On top an erect, flat-topped rim 0.02m. wide ... 19 February 1932 |
Fragment of bottom.
Raised base, rising. Rather carefully trimmed. Mold made.
Graffiti in dry clay.
Glazed all over including under side of base. Late black glaze with silvery lustre.
Attic clay.
Type ... 19 February 1932 |
Fragment of top and back and sides.
Double convex body, with lower part deeper than upper. Wheel made.
On top, depression around filling hole with diameter ca. 0.019m. Shallow groove surrounds depression ... 20 February 1932 |
Fragment of inscribed base and root of nozzle.
Flat base, slightly rising. Preserves part of a letter.
Purplish glaze covers outside. Inside, traces of red paint.
Hard red clay.
Type XVIII (post Sullan) ... 20 February 1932 |
Tip of nozzle broken off. No handle. Mold made.
Deep, rather angular body, with greatest diameter near bottom.
Top flat covered, surrounded by raised edge.
Long, deep, wide nozzle, with narrow flat top ... 20 February 1932 |
| Vertical band handle, tip and one side of nozzle broken away.
Double convex body, with decoration in relief on upper part; series of large and small grooved rectangles; row of dots above and below.
Small, ... 23 February 1932 |
| Left side of body broken off. Horizontal band handle broken away.
Body narrows slightly toward top. Medium wide rim, down sloping; set off from body by wide deep groove.
Long nozzle, flat on top; rather ... 24 February 1932 |
| Body, flat, angular, double convex.
On top, moulded band around filling hole, like slightly raised rim.
Long nozzle, pointed, with wick hole damaged from use.
Knob on left side, perforated near front ... 1 March 1932 |
Handle broken away.
Body with much rounded sides, with greatest diameter below center.
Slightly raised rim, set off by well-marked groove.
Perforated knob on left side of body.
Long nozzle, tubular (no ... 1 March 1932 |
Fragment of nozzle, rim, and base from large, multiple lamp.
Rim seems to be set off by groove and moulded edge, from which it extends inward horizontally.
Long nozzle, deep. Flat top with edges slighlty ... 1 March 1932 |
| Fragment of nozzle, top and sides. Top and end of nozzle broken away.
Body, sharply profiled.
Raised edge of top; just within, two small holes, spaced as though originally four; center of convex top, slightly ... 1 March 1932 |
| Vertical band handle broken away.
Double convex body.
Rim broad, decorated with ribs.
Discus plain, surrounded by groove; central filling hole.
Nozzle long, large, with central ridge and wide-spread, rounded ... 29 February 1932 |
| Shallow body, unevenly double convex, the broader upper part forming an incurving rim. Top open.
Body wall pulled outward with the thumb to form an open nozzle, now chipped at the end. Vertical handle ... 11 March 1932 |
| Long nozzle, flat top with concave sides and irregular shallow attachment groove. On top scratched in dry clay
Good black glaze inside and out, slightly silvery lustre.
Attic clay.
Type VI (late 5th ... 2 March 1932 |
Top of standard of small lamp. No handle.
Somewhat curving body, with greatest diameter below center.
On top, groove with small inner raised edge around central opening.
Small nozzle, with large wick hole ... 2 March 1932 |
Fragment of rim. Vertical band handle broken away.
Broad rim; curving, with relief decoration of heart motif.
Small top, concave.
Dull black glaze much chipped.
Gray clay.
Type XVIII of Corinth collection, ... 9 March 1932 |
| Open nozzle, with cothon handle. Mended from many fragments; part of the bottom missing.
Flaring rim, nearly flat at back, curving upwards toward front to form the pinched in nozzle. Low broad body with ... 29 February 1932 |
Left side broken away; lamp mended from two fragments.
Narrow rim, sloping; set off by deep groove from well rounded body.
Nozzle, flat on top, with letter "Δ" incised in the dry clay, on top of nozzle; ... 15 March 1932 |
| Small lamp with open socket for stand. Rim and nozzle broken away. Fragmentary.
Rounded body; apparently continuous with rim.
No handle; small solid knob on left side.
Bottom, rising slightly toward center ... 17 March 1932 |
Lamp mended from several fragments; part of back missing. Vertical band handle broken away. No base. Wheel made.
Rounded double convex body.
Top, slightly depressed. Nozzle, square at end, curving on top ... 17 March 1932 |
| Two small pieces missing, from rim and from body. Wheel made.
Double convex body. Depressed top.
Short nozzle, slightly turned up at fluked ends.
Base simulated by a groove round the bottom of the body ... 16 March 1932 |
A heavy triangular nozzle is preserved, rather shallow, flat on top, and with an extremely small wick hole in the tip.
The top of the nozzle merges with a small rim, down sloping round what appears to ... 19 March 1932 |
Miniature lamp. No handle.
Continuous rim, with rounded body.
Nozzle, flat on top; deep and broad.
High base.
Rather thin, lustrous black glaze, much flaked; base and lower front part of body, unglazed ... 30 March 1932 |
|
|
